Speco Technologies LPMT1 Long Pole Mount for O84S
Overview
The LPMT1 is a long pole mount engineered specifically for the Speco O84S camera. This accessory solves the installation problem of securing a camera at elevation in outdoor surveillance deployments — parking lots, perimeter lines, and facility entries where a fixed elevated vantage point improves incident documentation and coverage overlap. The mount delivers stable positioning without swaying or vibration transfer to the camera lens during wind or vibration events, which matters when you need consistent, usable footage across 24-hour recording cycles.
Compatibility
The LPMT1 mounts directly to the Speco O84S camera system. No adapter plates or intermediate hardware are required — the interface is direct. If your surveillance system uses a different Speco camera model or third-party hardware, verify compatibility before ordering; this mount is engineered for O84S integration only.
Environmental Rating
Rated IP23 for outdoor exposure. This means protection against water spray up to 60 degrees from vertical and dust intrusion sufficient for most pole-mounted outdoor installations. It is not rated for direct rain spray from below (that would require IP65 or higher) or for submersion scenarios. For high-pressure wash-down environments or coastal salt spray, confirm with the manufacturer whether additional corrosion treatment or sealing is needed.
Installation Notes
Mount the LPMT1 to a standard pole (diameter and material compatibility should be verified with your site conditions and the O84S documentation). Ensure the pole itself is structurally sound and properly grounded — the mount itself does not provide structural reinforcement. Tighten all fasteners securely to prevent micro-movement under wind load, which can degrade image stability over time. No power or signal pass-through is handled by the mount; route cabling independently to avoid strain relief issues.
