Panduit T150X000MPM-BK PXE™ Continuous Magnetic Label Tape
The Panduit T150X000MPM-BK delivers on-demand magnetic labeling for cable infrastructure, equipment panels, and network identification where repositionable markers matter. This 36mm-wide continuous tape cartridge combines label material and ribbon in a single unit that drops into the MP300 thermal transfer printer—no threading, no alignment guesswork. The magnetic backing bonds to steel enclosures, rack frames, and conduit without adhesive residue, and you can peel and reposition labels during commissioning or moves without leaving marks or losing stick.
Key Features
- 36mm (1.47") width × 1.5m (4.9 ft) continuous magnetic tape for custom-length labels
- Black-on-white thermal transfer printing for high-contrast readability in low-light server rooms and telecom closets
- Magnetic backing adheres to steel surfaces—no adhesive cleanup when you need to relocate or remove labels
- All-in-one cartridge design integrates label stock and ribbon for tool-free media changes in the MP300 printer
- PXE™ series compatibility ensures consistent print quality across Panduit's on-site labeling ecosystem
Installers working in environments where asset tags migrate—data centers with frequent rack reconfigurations, industrial control panels that see equipment swaps, or telecom facilities managing seasonal circuit changes—need labels that stick reliably but lift cleanly. The T150X000MPM-BK's magnetic substrate holds against vibration and vertical surfaces without the bond strength of permanent adhesive, so you're not scraping dried glue off powder-coated steel when a circuit gets reassigned or a server moves to another rack unit. The 36mm width accommodates two lines of 12-point text or a single line of large-format alphanumerics for voltage warnings and equipment ratings visible from walkways.
The cartridge architecture simplifies media management on job sites. Each T150X000MPM-BK unit arrives with 1.5 meters of label stock and the corresponding length of thermal ribbon pre-loaded in a single cassette. When you're down to the last few centimeters, you swap the entire cartridge in under ten seconds—no manual ribbon threading through guides, no risk of touching the thermal printhead with bare fingers and degrading print quality over time. This design eliminates the most common cause of field printer failures: ribbon jams from improper loading. You keep a spare cartridge in the truck, and downtime stays measured in seconds rather than the twenty minutes it takes to diagnose a ribbon path fault and re-thread.
For flat-surface applications only—this tape is engineered for panel faces, rack equipment labels, and conduit runs where the magnetic field sits flush against steel. It won't conform around curved pipe smaller than 4-inch diameter, and the magnetic hold relies on ferrous metal substrates. Aluminum junction boxes, fiberglass cable tray, and stainless-steel 316 enclosures (which are often non-magnetic) will require adhesive-backed label stock instead. The MP300 printer supports multiple Panduit cartridge types, so you can keep both magnetic and adhesive media on hand and select the right substrate for each task without changing printers.
