Hubbell HC6AGY03P Cat6A Plenum Patch Cord — 3ft Gray

Overview

The Hubbell HC6AGY03P is a 3-foot Cat6A patch cord with a plenum-rated jacket, designed for horizontal runs and equipment connections inside air-handling spaces where building codes require low-smoke, flame-retardant cabling. At 3 feet, it's the right length for patching between adjacent rack-mounted gear — switches to patch panels, PoE injectors to cameras, or NVR ports to a distribution switch — without excess slack cluttering the cabinet. Hubbell's Ascent line targets structured cabling deployments where jacket compliance and consistent performance margins matter more than rock-bottom cost.

Key Features

• Plenum (CMP) Jacket Rating: Meets NEC CMP requirements for installation in air-handling plenums and raised-floor environments — deploy this cord anywhere a riser or CM-rated cable would fail a code inspection. If your ceiling or floor void is used as an air-return path, plenum is not optional.
• Cat6A Performance: Supports 10 Gigabit Ethernet at full 100-meter channel lengths per TIA-568-C.2 — the HC6AGY03P patch segment won't be your bandwidth bottleneck when the rest of your horizontal plant is Cat6A. Also backward-compatible with Cat6 and Cat5e infrastructure at those respective speeds.
• 3-Foot Length: Sized for intra-rack or short inter-rack connections. Keeps cable management clean in high-density patch environments — long enough to route neatly, short enough to avoid coiling excess.
• Gray Jacket: Gray is a widely adopted convention for data/voice runs on color-coded patch panels, making port identification and MAC-layer troubleshooting faster during moves, adds, and changes.

Integration & Compatibility

The HC6AGY03P terminates in standard 8P8C (RJ-45) connectors and mates with any Cat6A or Cat6 keystone jack, patch panel port, or switch port. It works across Hubbell's structured cabling catalog and integrates cleanly into mixed-vendor patch panel environments. For IP camera deployments using PoE switches, ensure the full channel — patch cord, horizontal run, and equipment cord — is Cat6A to maintain 10GbE headroom as camera resolutions and bandwidth demands grow. Consult a structured cabling guide when planning plenum-zone cable routes to verify compliance with local AHJ requirements.

Frequently Asked Questions

Q: Is the HC6AGY03P suitable for use in air-handling ceiling plenums?

A: Yes. The HC6AGY03P carries a plenum (CMP) jacket rating, which meets NEC requirements for installation in air-handling spaces where low-smoke, flame-retardant cable is required by code.

Q: What speed does the HC6AGY03P support?

A: As a Cat6A patch cord, it supports 10 Gigabit Ethernet at channel lengths up to 100 meters, and is backward-compatible with Cat6 (1GbE) and Cat5e (100MbE/1GbE) infrastructure.

Q: Can I use the HC6AGY03P with Cat6 patch panels and switches?

A: Yes. Cat6A is backward-compatible with Cat6 and Cat5e equipment. You will be limited to the lower category's performance when mixing, but the cord itself will not introduce any incompatibility.

Q: Is 3 feet the right length for intra-rack patching?

A: For most 1U–2U spacing between patch panel and switch within the same rack, 3 feet is a common and practical length. Measure your specific rack layout before ordering multiples to avoid excess slack.