StarTech HKLP100 100-Foot Hook-and-Loop Cable Management Roll

Overview

The StarTech HKLP100 is a 100-foot continuous roll of hook-and-loop fastener tape designed for bundling and organizing cables in server racks, network cabinets, and structured wiring installations. At 0.7 inches wide and weighing just 1.1 lb for the full 100-foot roll, it gives installers a cut-to-length solution that eliminates the waste and inconsistency of pre-cut zip ties. Whether you are dressing a 42U rack full of patch cables or routing surveillance camera runs back to a head-end closet, having a continuous roll on hand means you cut exactly what each bundle requires — no leftover stubs, no over-tightened ties that crimp jacket insulation.

Unlike single-use zip ties, hook-and-loop wraps are fully reusable. When a cable run changes — a camera gets relocated, a switch port gets reassigned — you unwrap, re-route, and re-wrap without cutting anything out. That matters on active infrastructure where changes are routine. The HKLP100 belongs in every field technician's bag and every cable management category on a structured wiring BOM.

Key Features

• 100-Foot Continuous Roll: Cut segments to any length needed for each bundle — short wraps for patch panel dressing, longer runs for vertical cable managers. One roll handles an entire rack installation without running out mid-job, avoiding the friction of mismatched cut-tie lengths across a cabinet.
• 0.7-Inch Width: Wide enough to grip a substantial bundle securely without the tape buckling or rolling on itself during wrapping. Narrow enough to fit comfortably between adjacent cables in tight 1U and 2U spaces where clearance is limited.
• Reusable Hook-and-Loop Construction: Peel open, re-route, re-fasten — no tools required and no replacement materials consumed. On a surveillance installation where camera positions get adjusted during commissioning, reusable wraps save time and reduce consumable cost compared to cutting out zip ties on every change.
• -10°C to 80°C Operating Range (14°F to 176°F): Handles the thermal cycling inside active rack enclosures where dense switching and compute equipment push ambient temperatures well above room level. The 80°C upper limit means the tape stays bonded even in poorly ventilated IDF closets or outdoor enclosures with solar gain — conditions that degrade cheaper fasteners.
• Matched Storage Temperature (-10°C to 80°C): The roll can be stored in an unheated warehouse or vehicle without the hook-and-loop material becoming brittle or losing adhesion before it ever gets used — relevant for installers who stock materials in trucks or outdoor job trailers during seasonal temperature swings.
• Lightweight at 1.1 lb for 100 Feet: The full roll adds negligible weight to a tool bag or parts kit. Carrying a complete roll to every job site is practical, so technicians always have material on hand rather than rationing pre-cut ties.
• Cut-to-Length Flexibility: A continuous roll adapts to any bundle diameter or cable count. Thick fiber trunks, thin patch cords, and mixed-gauge power-and-data bundles each get a wrap sized to the actual bundle — no guessing at pre-cut lengths before the job starts.

Integration and Compatibility

The HKLP100 is compatible with any cable type and diameter that fits within a standard wrap — copper patch cables, fiber jumpers, coax, low-voltage security wiring, and power cords. It works alongside standard cable management hardware including vertical and horizontal cable managers, D-rings, and J-hooks. For integrators building out network video recorder installations or structured cabling backbones, the roll pairs naturally with patch panels, cable trays, and rack-mount equipment. Consult a server rack accessories guide for a complete cable management bill of materials. When planning camera-to-switch runs, pair this with a PoE switch selection that matches your channel count and power budget — tidy cable management starts at the switch and runs all the way to the camera mount.

Frequently Asked Questions

Q: How long is the StarTech HKLP100 roll, and can I cut it to custom lengths?

A: The HKLP100 is a 100-foot (30.5 m) continuous roll that you cut to any length needed. There is no minimum cut length — trim segments as short or as long as the bundle requires.

Q: What is the width of the tape on the HKLP100?

A: The tape is 0.7 inches (1.9 cm) wide — wide enough for a secure grip on most cable bundles, and narrow enough to work in tight rack spaces.

Q: What temperature range can the HKLP100 handle?

A: Both operating and storage temperature range from 14°F to 176°F (-10°C to 80°C). This covers active rack enclosures, IDF closets, and seasonal storage in unheated vehicles or warehouses.

Q: Is the HKLP100 reusable, or is it a one-time fastener like a zip tie?

A: The hook-and-loop construction is fully reusable. Unwrap, re-route, and re-fasten as many times as needed without any tools or replacement material.

Q: What is the warranty on the StarTech HKLP100?

A: The HKLP100 carries a 2-year manufacturer warranty.

Q: How much does the full 100-foot roll weigh?

A: The complete roll weighs 1.1 lb (0.5 kg), making it practical to carry in a field technician's bag without adding meaningful weight to a tool kit.

Marty Allison

The spec that often gets overlooked on hook-and-loop rolls is the temperature rating — and on the HKLP100 that 80°C upper limit is legitimately useful. I have seen cheaper hook-and-loop material lose its grip in dense 2-post racks where the ambient temperature climbs well past 60°C during peak loads. At 100 feet per roll, the HKLP100 is sized for a full rack build rather than a quick patch job, and at 1.1 lb it stays in the bag without complaint.

Technical Highlights:

• 100-Foot Roll Length: Enough material to dress an entire 42U rack — vertical cable managers, patch panel fronts, and horizontal bundle runs — without swapping rolls mid-installation.
• 0.7-Inch Tape Width: Hits the practical sweet spot for most rack cable bundles: wide enough to hold 20+ patch cords cleanly, narrow enough to maneuver in 1U gaps without catching adjacent cables.
• -10°C to 80°C Rated: Survives the thermal environment of active switching and compute equipment — and stores safely in a truck through winter job sites without the material degrading before it gets used.

Deployment Considerations:

• Cut segments on the longer side for bundle runs that will be opened frequently during commissioning — it is faster to peel a 6-inch wrap than a 2-inch one when you are re-routing under time pressure.
• Hook-and-loop does collect dust and lint over time in high-particulate environments (raised-floor data centers, warehouse floors). Plan periodic inspections on critical bundle points where tape grip is load-bearing on heavy cable weights.

The HKLP100 earns its place on a rack installation BOM for any multi-camera surveillance head-end or structured wiring closet where cable changes during commissioning are expected and zip-tie rework time is a real cost.