Panduit OM5 2F 2MM PC Ofnp LC Uniboot/lc Unibea - FW2RPU1U1NNM034

Panduit FW2RPU1U1NNM034 OM5 2-Fiber Plenum LC Uniboot Patch Cable, 34m

Overview

The Panduit FW2RPU1U1NNM034 is a factory-terminated, 34-meter (111.6 ft) OM5 wideband multimode fiber patch cable from the QuickNet™ pre-terminated infrastructure line. It ships ready to install — no field termination, no polishing, no loss testing on-site — making it the right choice for data center backbone links, telecom room cross-connects, and entrance-facility runs where deployment speed and repeatable insertion loss matter. The 2-fiber configuration pairs with a dual LC uniboot connector on each end, which consolidates two fibers into a single, space-saving ferrule housing that reduces cable management bulk in high-density patching environments.

OM5 wideband multimode fiber (50/125µm) supports short-wavelength division multiplexing (SWDM) and is backward-compatible with OM4 transceivers — meaning you can commission this cable in a 40G or 100G OM4 link today and transition to parallel-optic or SWDM 100G/400G applications without pulling new glass. That future-path value matters in any structured cabling build-out where conduit fill is a constraint.

Compatibility

Designed to integrate with Panduit QuickNet™ modular plug-in cassettes, patch panels, and trunk system housings that accept LC duplex or LC uniboot ports. The LC uniboot connector mates with standard LC duplex adapters — no proprietary adapter required — so it is compatible with any switch, transceiver, or active equipment port accepting LC duplex connectors, including ports on Cisco, Juniper, Arista, and HPE switching platforms. The cable is compliant with TIA-568.3-D, ISO/IEC 11801, and ANSI/TIA-942-B, making it suitable for fiber optic cabling deployments that must satisfy those standards by design spec or formal audit.

Installation Notes

The OFNP (plenum) flammability rating satisfies NEC Article 770 requirements for installation in air-handling spaces and open ceiling plenums — this cable can run through HVAC return-air plenums without conduit where code permits, which matters in retrofit installs where conduit add is cost-prohibitive. At 34 meters, confirm the run length fits within OM5 channel reach for your transceiver type: 100G-SR2 and 40G-SWDM4 specs define maximum channel distances that must include all patch cords, trunk segments, and splice losses. Use a fiber optic loss test set to verify end-to-end insertion loss on commissioning — factory termination reduces variable, but channel qualification is still required on any standards-compliant installation.