Panduit FW2U1U1NNM011 OM5 Fiber Optic Patch Cable - FW2RPU1U1NNM011

Panduit FW2RPU1U1NNM011 OM5 LC Uniboot Plenum Fiber Patch Cable

Overview

The FW2RPU1U1NNM011 is a pre-terminated fiber optic patch cable from Panduit's QuickNet™ line — 11 meters (36.1 ft) of OM5 wideband multimode 50/125µm fiber with LC uniboot connectors on both ends and an OFNP plenum jacket. OM5 supports short-wavelength division multiplexing (SWDM), which lets you push 40G and 100G over a single two-fiber run instead of requiring parallel fiber arrays — directly relevant when you're trunking between spine switches or patching into transceivers in high-density data center rows. The plenum (OFNP) jacket satisfies building code in air-handling spaces without conduit — install it in raised-floor and above-ceiling runs through environmental air plenums where a riser-rated cable would require additional enclosure. The uniboot form factor consolidates both fibers into a single 3mm connector footprint, which matters in 1U high-density patch panels where conventional duplex connectors leave you fighting for space at the faceplate.

Compatibility

Designed for data center and telecommunications infrastructure deploying LC-port transceivers and panels: pairs directly with Panduit QuickNet cassette-based pre-terminated systems, standard LC-port SFP+ and QSFP28 transceivers, and any TIA-568.3-D or ISO/IEC 11801 compliant LC patch panel. Suited for 40GBASE-SR4, 100GBASE-SR4, and SWDM4 applications operating over OM5 fiber across enterprise core switching, network switching infrastructure, and structured cabling distribution frames. Verified against ANSI/TIA-942-B data center cabling standards — confirm your transceiver and panel manufacturer specifies OM5 compatibility before deploying on legacy OM3 or OM4 infrastructure where modal bandwidth differences may affect link budget.

Installation Notes

OFNP plenum rating applies specifically to installations in environmental air-handling spaces — do not substitute a riser (OFNR) cable in plenum spaces to meet fire code. The uniboot housing uses a single strain-relief boot; maintain minimum bend radius per TIA standards (typically 10x cable diameter under load) to avoid insertion loss at the connector interface. At 11m, confirm the run length fits within your OM5 channel budget for the target data rate — OM5 supports 100G SWDM4 to 150m, well beyond this patch length. Fiber installation accessories such as cleaning tools and inspection scopes are recommended before first insertion into any LC port.