Panduit FW2LU1U1NNM029 OM5 2F 2MM PC Lszh LC Uniboot/LC Unibea - FW2RLU1U1NNM029

Panduit FW2RLU1U1NNM029 OM5 2-Fiber LC Uniboot to LC Duplex LSZH Patch Cable

Overview

The Panduit FW2RLU1U1NNM029 is a factory pre-terminated OM5 wideband multimode fiber patch cable from the QuickNet™ platform — a 2-fiber, 29-meter (95.1 ft) assembly with LC Uniboot connectors on one end and LC Duplex on the other. The Uniboot connector consolidates both fibers into a single-boot housing, cutting tray and pathway fill nearly in half versus standard duplex runs — a direct benefit in congested main distribution frames and high-density patch panels where space is a managed resource. The LSZH jacket eliminates the halogen release risk in enclosed plant rooms, plenum corridors, and data hall cable trays where local codes mandate low-smoke materials. Pre-terminated at the factory means no on-site polishing, no field cleaving, and consistent endface geometry from the first pull to the last.

Compatibility

Designed for deployment into fiber optic infrastructure built around TIA-568.3-D, ISO/IEC 11801, and ANSI/TIA-942-B structured cabling standards — the dominant specifications in commercial data centers, telecommunications rooms, entrance facilities, and equipment distribution areas. LC Duplex is the near-universal connector type on SFP+ and SFP28 transceivers, so the LC end drops directly into top-of-rack switches, storage arrays, and active equipment. The LC Uniboot end mates with Panduit QuickNet™ fiber cassettes, patch panels, and adapter plates that accept standard LC duplex interfaces. OM5 glass (50/125µm) supports both 100G SWDM4 shortwave division multiplexing and legacy OM4-grade 10G/40G/100G applications, so this cable does not strand you if transceiver technology changes before the next infrastructure refresh. Verify that your patch panel adapter accepts LC Uniboot geometry — not all LC duplex panels are Uniboot-compatible without an adapter sleeve.

Installation Notes

At 29 meters, this assembly is sized for inter-rack and zone-to-zone runs within a data center floor, not short patch bay hops. Route bend radius per TIA-568 minimums — OM5 glass is sensitive to tight bends at high bit rates. The single-boot Uniboot housing requires a Uniboot-compatible release tool for polarity reversal; standard duplex clip tools will not work. LSZH compounds are stiffer than PVC or riser-rated jackets at low ambient temperatures — allow cable to acclimate before routing in cold-aisle environments. Confirm polarity scheme (Method A, B, or C) against the far-end cassette before installing — pre-terminated assemblies cannot be re-polished in the field.