Middle Atlantic NM Radius Fiber Outside E - PN10F19FW

Middle Atlantic PN10F19FW Eclipse PN10 Radiused External Corner Elbow

Overview

The PN10F19FW is a radiused extruded elbow fitting designed for the Middle Atlantic Eclipse PN10 cable management system. It handles right-angle turns around external corners — the specific scenario where a straight raceway run meets an outward-facing corner and must change direction without kinking cable or creating an abrupt 90-degree bend. The radiused profile distributes bend stress across the turn rather than concentrating it at a single point, which matters for fiber optic runs where minimum bend radius is a hard limit, not a guideline. Color is Fog White to match the PN10 raceway family. The model number PN10F19FW identifies this as the fog white variant of the external elbow for the PN10 series.

Compatibility

Designed exclusively for the Middle Atlantic Eclipse PN10 series raceway. Install alongside other PN10 fittings — flat elbows, inside corners, couplers, and end caps — to complete a continuous, matched raceway system. Not cross-compatible with other Middle Atlantic raceway series or third-party raceways of differing cross-section dimensions. Fog White finish is matched to PN10 raceway sections specified in the same color family; mixing with other color variants will produce a visible mismatch.

Installation Notes

Position at external (outward-facing) corners only — this fitting is not interchangeable with inside-corner fittings, which have an inverse geometry. The radiused elbow snaps or secures into the raceway run per standard PN10 assembly practice; no special tooling is required beyond what the broader PN10 installation demands. Verify cable fill does not exceed the raceway's rated capacity before routing through the elbow, as the bend geometry slightly reduces usable cross-section at the turn point.