Lifesafety Power FPO150/250-2D8P2M8NLCE6M1 Managed Power Supply with Supervised Distribution

Overview

The FPO150/250-2D8P2M8NLCE6M1 is a dual-rail, field-selectable power supply designed for distributed security installations requiring independent supervision and selective sourcing across multiple circuits. Configure the unit for either 150W (12A @ 12VDC or 6A @ 24VDC) or 250W (20A @ 12VDC or 10A @ 24VDC) output, with eight independently managed distribution module outputs fused at 3A per output. Each output can be assigned to Bus 1 or Bus 2, enabling split-load topologies where, for example, critical cameras or access control hardware draws from one supervised rail while auxiliary loads like PIRs or signaling devices draw from the second. This architecture reduces single-point-of-failure risk in warehouse automation and perimeter surveillance deployments where uptime is tied to facility operations.

Compatibility

This supply integrates with legacy and contemporary 12VDC or 24VDC powered endpoints—including older IP cameras without PoE support, door locks, alarm panels, strobe controllers, and gate operators. The class 2 auxiliary outputs (2.5A per output) are rated for low-voltage distribution, making this unit suitable for mixed-load systems where video cameras, intercom amplifiers, and relay control circuits coexist on a single power backbone. Consult endpoint datasheets to confirm voltage and current draw against the 3A fused-output ceiling and 2.5A aux-output limit.

Installation Notes

The E6 enclosure (30H × 23W × 6.5D inches) mounts in standard DIN rail cabinets. Incoming AC and outgoing DC terminals accept 12/2 through 10/2 AWG wire; confirm local electrical code compliance before deployment. The dual-bus architecture requires field jumper or software configuration to assign each output to the appropriate rail—consult the installation guide for bus assignment procedure and voltage verification. Backorder status applies; confirm availability and lead time with your supplier before design-freeze.