Lenovo 00KA607 X ENT 1U Cable Mgmt ARM (cma)

Lenovo 00KA607 1U Rack Cable Management Arm

Overview

The Lenovo 00KA607 is a 1U cable management arm (CMA) designed for X Enterprise rack deployments where rear-cable discipline directly affects serviceability. At 22.10 inches long and 9.70 inches wide, the 00KA607 provides enough reach and lateral span to route and retain server or appliance cabling without forcing a full cable disconnect during slide-out maintenance — the practical payoff in dense rack environments where downtime per service event matters. Weighing 2.70 lb, it adds minimal load to the rear of a managed rack unit.

Compatibility

Designed for Lenovo X Enterprise 1U rack systems. Verify your specific server or appliance model against Lenovo's compatibility matrix before ordering — the 1U form factor constrains fit to single-rack-unit configurations and is not interchangeable with 2U or tool-less CMA variants used in other Lenovo rack families. Review compatible Lenovo rack infrastructure options to confirm the correct CMA pairing for your chassis. If you are also specifying rack enclosures or rack accessories, cross-reference the rear-panel cable exit geometry with this arm's 9.70-inch width to avoid clearance conflicts with adjacent patch panels or PDUs.

Installation Notes

Dimensions are 22.10 x 9.70 x 4.10 inches (L x W x H) — account for the 4.10-inch height stack when planning vertical cable routing alongside adjacent 1U units. Manufactured in Mexico (country of origin: MX). No specific torque specs or tool requirements are documented in available evidence; follow Lenovo's rack installation guide for the target server model. Confirm rear-rail depth compatibility before installation, as CMA reach requirements vary by rack depth.