i-PRO IPS-SVR-PWRCORD-EU European AC Power Cord for i-PRO Servers (8 ft)
The IPS-SVR-PWRCORD-EU is the factory-spec 8-foot European AC power cord for i-PRO server and NVR appliances. The cord uses the standard CEE 7/7 (Schuko) plug for continental European mains and an IEC 60320 C13 connector at the appliance end, matching the inlet used on the i-PRO server PSU. Genuine OEM cords carry the appropriate insulation rating, conductor gauge, and HAR/CE markings required for compliant installation in EU jurisdictions.
Key Features
- OEM i-PRO power cord designed for EU server/NVR appliance deployments
- CEE 7/7 (Schuko) plug for 230 V continental Europe mains
- IEC 60320 C13 appliance-side connector
- 8-foot (approximately 2.4 m) flexible jacketed cable
- HAR-rated insulation and EU safety markings
- Direct replacement for damaged or missing factory cords
- Spare/replacement-grade for fleet maintenance
Power cord substitution is a common source of avoidable warranty issues. Off-the-shelf cords vary widely in conductor gauge and insulation quality, and a thin-gauge cord paired with a high-current PSU can warm noticeably under sustained NVR write load. Using the OEM cord keeps the install fully within spec and avoids questions during regulatory inspection of compliant EU sites.
Verify the cord is rated for the actual circuit at the install site. For 230 V single-phase circuits the standard Schuko-to-C13 cord is correct; for 16 A rack PDU outlets or 3-phase derivative circuits, an alternate cord may be required. Always route the cord clear of the rack rear airflow path and avoid sharp bends at the C13 connector strain relief. Replace any cord showing insulation cracking, plug discoloration, or pin pitting.
