i-PRO WV-Q118B Wall Mount Bracket
Overview
The WV-Q118B is a wall-mounted bracket designed to secure i-PRO indoor dome surveillance cameras to concrete, masonry, and similar solid wall surfaces. It solves the positioning problem when you need a camera mounted horizontally away from ceiling-mounted locations — typical for retail floors, office corridors, and facility perimeters where wall mounting offers better sight line and access control over ceiling placement. The bracket supports a total system weight of approximately 3.8 kg (camera plus bracket), which covers standard indoor dome units in the i-PRO portfolio.
Compatibility
The WV-Q118B is designed exclusively for i-PRO indoor dome cameras. Verify your specific camera model against the i-PRO compatibility matrix before ordering — this bracket is not suitable for PTZ cameras, turrets, or cameras from other manufacturers. The datasheet notes that mounting incompatible cameras will result in failure and potential injury.
Installation Notes
Wall mounting requires M4 bolts (4x required) with a minimum pull-out force of 196 N (20 kgf) per fastener — choose bolts rated for your wall material (concrete anchors for masonry, expansion bolts for solid concrete). The bracket itself ships without mounting hardware; you source bolts based on your wall composition and the combined weight of the camera and bracket assembly. Installation demands technical experience due to critical safety factors: the mounting location must withstand the full 3.8 kg load without deflection, and all fasteners must be torqued securely to prevent camera drop. Do not install in environments subject to salt spray, corrosive gases, high vibration (vehicle/ship proximity), or rapid temperature swings that cause condensation. Perform periodic inspections of the wall anchor points to detect corrosion or degradation before camera failure occurs. The bracket includes safety covers (labeled 1 and 2 in the datasheet) that must be fully seated and confirmed in place — these are anti-drop safety features.
