HPE ML350 GEN11 LFF EMB SATA CBL KIT - P47225-B21

HPE P47225-B21 Large Form Factor Embedded SATA Cable Kit

Overview

The HPE P47225-B21 is the OEM embedded SATA cable kit designed for Large Form Factor (LFF) drive configurations in HPE ProLiant ML350 Gen11 tower servers. If you're expanding internal storage or replacing a damaged SATA cable assembly in an ML350 Gen11 build, this kit provides the correct factory-spec wiring — avoiding the signal integrity issues and mechanical fitment problems that arise from using generic third-party cables in a chassis engineered to tight cable-routing tolerances. Using the correct HPE-sourced cable ensures the embedded SATA controller on the Gen11 platform sees the proper impedance and connector keying for reliable drive communication across all populated LFF bays.

Compatibility

Designed specifically for the HPE ProLiant ML350 Gen11 tower server with LFF drive cage configurations. The P47225-B21 is specific to the embedded SATA backplane path — not interchangeable with SAS expander or Smart Array cabling. Confirm your ML350 Gen11 is configured for LFF bays (up to 3.5-inch drives) before ordering; the Small Form Factor (SFF) variant uses a different cable kit. This kit is not compatible with ML350 Gen10 or earlier generations, which use different backplane connector layouts. For broader server components and accessories, verify your ML350 Gen11 system board revision against HPE's QuickSpecs before installation to confirm embedded SATA port count matches your drive population plan.

Installation Notes

Route cables per the ML350 Gen11 maintenance and service guide — HPE chassis designs route LFF SATA cables along defined cable guides to maintain airflow and prevent pinch points near drive cage retention brackets. The SATA interface operates at standard SATA signal levels; no jumper configuration is required. Ensure the server is fully powered down and discharged before disconnecting or reseating any internal cable assembly. Country of origin: CN.