Honeywell HA35JCBHDV 35 Series Dome Junction Box
Overview
The HA35JCBHDV is a junction box built for the Honeywell 35 Series dome camera mount line. It gives installers a dedicated back box for routing and terminating cable behind a dome camera, keeping splices and connectors out of the weather and out of sight instead of leaving them exposed above a ceiling tile or behind a surface-mount bracket. This is the part you spec when a 35 Series dome is going on a wall or ceiling location that needs concealed cable management rather than an exposed pigtail.
Compatibility
The HA35JCBHDV is built for the Honeywell 35 Series dome camera family. Confirm your specific dome model against the 35 Series mount pattern before ordering — junction boxes in this line are matched to a specific mount interface, not universal across Honeywell's full Honeywell catalog.
Installation Notes
Manufacturer documentation for this SKU is limited to a general product category listing rather than a published installation sheet. Verify conduit entry points, wall vs. ceiling mounting hardware, and cable clearance against the specific 35 Series dome model before rough-in. If you're planning cable runs for a new dome camera installation, review a PoE planning guide before finalizing box placement and conduit routing.
Pair this junction box with a compatible dome from the IP cameras lineup, and check camera mounts and housings for the matching bracket if your install calls for a pole or corner adapter.
