Geovision 84-VS110-110U Video Server VS11
Overview
The Geovision 84-VS110-110U is a single-channel analog-to-IP video server that bridges legacy analog CCTV systems into modern network surveillance infrastructures. It accepts composite video input from existing analog cameras and encodes the signal as H.264 IP streams, eliminating the need to replace working analog hardware during network migration. This is the right tool when you're modernizing piecemeal — keeping analog cameras online while gradually building out an IP backbone.
Compatibility
The VS11 integrates with any network-based video management system that accepts H.264 RTSP streams over standard Ethernet. It is compatible with Geovision GV-Control Center and third-party ONVIF-capable VMS platforms. Input accepts standard NTSC or PAL composite video signals (RCA-type connectors typical on analog cameras and DVR outputs). Deploy in mixed analog/IP environments where you need to ingest one or more analog feeds into a centralized IP recording system without hardware replacement.
Installation Notes
The device draws power via PoE (802.3af standard), eliminating the need for a separate power supply — wire it directly into any 802.3af-capable PoE switch port. Note: the datasheet explicitly states this unit does not support PoE+ or GPS functions. Composite video input should be shielded and run separately from AC power lines to avoid 60Hz hum in the image. Maximum cable run depends on your network infrastructure — standard Ethernet limits apply (100m Category 5e/6 for 100 Mbps, longer runs for gigabit if available).
What's in the Box
- 1x Geovision 84-VS110-110U Video Server VS11
- 1x RJ-45 Ethernet cable (length not specified in evidence)
- 1x Composite video input connector
- Documentation and driver disk
