Panduit TFC5WH-X Pan-Way LD5 Surface Raceway Tee Fitting
The Panduit TFC5WH-X extends LD5 surface raceway runs in a tee configuration, providing a 90-degree branch point for low-voltage cabling in commercial installations. Designed for data, fiber, and electrical wiring up to 50V, this white PVC fitting integrates with Pan-Way LD5 and LDPH5 raceway systems to route cable around building obstructions, across open walls, or through spaces where in-wall installation isn't feasible. The one-piece hinged design eliminates fumbling with separate cover plates during pulls, and factory-applied adhesive backing mounts directly to drywall, concrete, or metal studs without drilling.
Key Features
- One-piece hinged design — snap cover closed after cable placement, no loose parts
- Adhesive backing — mounts to most surfaces without fasteners or surface prep
- Bend radius control — maintains TIA/EIA-compliant cable geometry through the tee junction
- UL94V-0 and FT4 rated PVC — self-extinguishing material meets fire and building codes
- White finish — matches standard LD5 raceway and most office or residential interiors
- 10-pack packaging — enough fittings for typical floor or suite retrofit without excess inventory
The TFC5WH-X measures 4.04 inches wide by 2.58 inches long by 0.64 inches tall (102.6 × 65.5 × 16.3 mm), sized to accept LD5 raceway base and cover on all three legs. The internal channel maintains a controlled bend radius through the tee junction, preventing kinks in Cat6A, fiber, or 18 AWG power pairs that would degrade performance or violate TIA-568 installation standards. PVC construction is non-conductive and rated UL94V-0 for flame spread, meeting NEC Article 800 requirements for communications raceway in plenum-equivalent or general-purpose spaces when used with appropriate raceway sections.
Install the TFC5WH-X where a straight raceway run must branch to serve a perpendicular wall, split to opposing cubicles, or feed a wall-mounted device from a baseboard trunk line. Peel the adhesive liner, press the base onto the mounting surface, and snap LD5 raceway sections into the three connection points. The hinged cover opens 180 degrees for cable loading, then clicks shut to conceal and protect conductors. White finish blends with painted drywall or trim in offices, classrooms, patient rooms, or residential smart-home installations where surface-mount wiring is preferred over demolition and patching.
Panduit supplies the TFC5WH-X in 10-unit packs (50 per carton) for commercial integrators running multi-room access control, nurse call, or IP camera retrofits. TIA/EIA compliance and UL94V-0 listing satisfy AHJ inspections and low-voltage permit requirements, and the snap-together Pan-Way system cuts labor compared to flex conduit or adhesive-mount wire clips. Compatible raceway sections, corners, and boxes are stocked under the same Pan-Way LD5 family for unified aesthetics and simplified BOMs.
