Cradlepoint 170712-000 2x10 GPIO Cable
Overview
The Cradlepoint 170712-000 is a 2.3-meter 2x10 GPIO cable engineered to connect industrial control systems and edge appliances to Cradlepoint COR platform routers. This cable bridges GPIO (General Purpose Input/Output) interfaces, enabling discrete sensor and relay integration at remote sites without requiring separate control modules. Deploy this when you need alarm signaling, door sensors, or equipment state monitoring wired directly into an IBR1700 or COR Extensibility Dock — a common requirement in telecom shelters, security installations, and unattended industrial locations.
Compatibility
This cable works with the Cradlepoint IBR1700 industrial router and the COR Extensibility Dock (model 170700-000). The 2x10 GPIO connector is the standard interface on these devices for discrete I/O expansion. If you are deploying an IBR1700 in a site with local alarm panels, generator controls, or door-access relay outputs, this cable is the direct connection point — no adapters or third-party breakout boards needed.
Installation Notes
Cable length is 2.3 meters (7.5 feet) — sufficient for most rack and wall-mount scenarios within a shelter or cabinet. No external power or termination required; GPIO carries only logic-level signals (typically 3.3V or 5V per your COR device configuration). Standard industrial practice: secure the cable away from high-voltage power runs to avoid noise coupling. No special tools are needed beyond standard installation hardware for wall routing or cable management.
What's in the Box
