Hanwha FC15-001430A Replacement Optical Cover
The Hanwha FC15-001430A is an OEM optical cover used as a maintenance and spare part across compatible Hanwha dome and turret cameras. The cover is the camera's primary outer optic and weather barrier, and Hanwha builds it to the same tolerances as the cover shipped from the factory. Replacing a damaged or hazed cover with an OEM unit restores the camera's published low-light performance, IR throw distance, and ingress protection.
Key Features
- Factory Hanwha optical cover, moulded to the original camera spec
- Optical-grade polymer with anti-reflective inner finish to minimize IR ghosting
- UV-resistant exterior coating slows discoloration in outdoor service
- Pre-fitted gasket channel for re-installation with a new seal
- Compatible with the camera's tamper screw torque pattern (use the Hanwha service torque)
- Drop-in mechanical fit; no firmware or focus re-calibration required when the camera body is undisturbed
- Cost-effective alternative to full camera RMA after physical damage
Field replacement of an optical cover is typically a 5-10 minute operation: remove the housing tamper screws, lift the cover assembly, swap in the new cover with a fresh gasket and desiccant pack, and re-torque the screws. The whole operation avoids dismounting the camera, which preserves the field of view and removes the need to re-aim and re-program privacy masks. For ceiling and pole installations this saves a lift rental on the second trip.
Confirm the part number printed on the original cover or quoted on the camera's spec sheet before ordering. Optical covers are model-specific even when two cameras look identical externally — the lens cut-out, IR mask, and gasket profile differ between SKUs. Stocking a small assortment of common cover SKUs along with replacement gaskets and desiccants is good practice for any team that maintains outdoor Hanwha camera fleets.
