Panduit CLT75F-C20 Corrugated Loom Tubing
The Panduit CLT75F-C20 delivers fast-install cable protection for bundled runs in commercial security, AV, and low-voltage installations. This 100-foot roll of 0.75-inch black polyethylene corrugated tubing features a full-length slit that lets you route pre-terminated cables or retrofit protection onto existing harnesses without disconnecting ends—eliminating the need to thread connectors through solid tubing and cutting installation time on rack-to-endpoint runs, camera trunk lines, and equipment-room cable bundles.
Key Features
- Full-length slit design enables retrofit installation without disconnecting cable ends
- 0.75" (19.05mm) inside diameter accommodates bundled Cat6, coax, and small-gauge power runs
- Corrugated polyethylene construction resists crush, impact, and abrasion in plenum-adjacent and wall-chase routing
- UL94-HB flammability rating and 122°F (50°C) maximum operating temperature for indoor applications
- 100-foot continuous length minimizes mid-run splices on long horizontal and riser pulls
- Secures with standard cable ties at regular intervals for permanent routing
Commercial installers face a recurring problem: protecting bundled cables after termination. Solid loom tubing requires threading every connector through the entire length—impractical on 100-foot runs or when retrofitting protection onto live systems. The CLT75F-C20's longitudinal slit solves this by allowing lateral cable insertion at any point along the tubing. Open the slit, press the bundle into the corrugated channel, and secure with cable ties every 12–18 inches. The corrugated wall structure provides crush resistance in cable trays and wall boxes while maintaining flexibility for 90-degree bends around corners and rack edges. The 0.762-inch inner diameter handles typical security bundles—three Cat6 cables plus 18/2 power, or a quad-shield RG6 coax alongside a twisted-pair run—while the black polyethylene exterior resists abrasion from repeated contact with drywall edges, conduit fittings, and metal studs during long pulls.
Panduit engineers this tubing for the realities of structured-cabling environments where cables exit conduit and transition to open routing. The material's UL94-HB flammability rating meets code for non-plenum indoor spaces—think IDF closets, equipment racks, and wall-chase runs between access-controlled doors and control panels. The 122°F temperature ceiling accommodates normal HVAC conditions but excludes attic or near-boiler routing; for those environments, step up to Panduit's higher-temp loom variants. The 100-foot roll length matches standard cable spools, letting you protect an entire horizontal run from patch panel to end device without mid-span splicing or coupling. Install crews appreciate the packaging efficiency: one roll protects four 25-foot camera drops or a single 100-foot backbone run without leftover waste or the need to stock multiple smaller spools.
This tubing meets RoHS compliance requirements for federal and state installations. Panduit backs the CLT75F-C20 with the same design-and-manufacturing rigor that governs their copper infrastructure and cable-management systems—consistent wall thickness, predictable slit-closure tension, and dimensional accuracy that ensures compatibility with Panduit's clip and tie-mount accessories for professional-grade cable routing and protection.
