Code Blue SLNP0153 4G/LTE-A Cellular Expansion Kit
Overview
The Code Blue SLNP0153 is a 4G/LTE-A cellular expansion kit that adds mobile network connectivity to CB9 cameras. Deploy this where traditional wired IP networks are impractical—remote gates, rural perimeters, temporary job sites, or backup uplink scenarios. The SLNP0153 bridges the gap between off-grid locations and your VMS by routing video and alerts over LTE-A instead of hardwired Ethernet, eliminating the need for conduit runs or extended PoE line distances. This matters when site infrastructure doesn't support fiber or copper runs, or when you need failover redundancy without the capital cost of dual fiber paths.
Compatibility
The SLNP0153 integrates exclusively with Code Blue CB9 camera models. Before ordering, verify your CB9 unit's firmware version and port configuration—cellular kits require specific hardware compatibility to function. Consult your CB9 documentation or integrator for any required pre-configuration steps on the camera side. Do not assume plug-and-play behavior without confirming compatibility with your exact CB9 revision.
Installation Notes
Install the kit in an area with reliable LTE-A signal—marginal reception degrades video bitrate and causes dropouts. Mount the antenna away from metal obstructions and RF interference sources (industrial equipment, high-voltage lines, dense rebar). Ensure your cellular service plan supports video streaming; data caps and throttling policies vary significantly by carrier—confirm bandwidth and throughput headroom before deployment. Test connectivity and failover behavior in staging before going live. The CB9 must retain Ethernet connectivity as a fallback; do not substitute cellular for primary network access in mission-critical installations without redundancy.
