Server Technology C2WG36TE-YQME2966/C 3-Phase 60A Rack PDU

The Server Technology C2WG36TE-YQME2966/C is a 3-phase, 208V WYE-configured rack power distribution unit built around a 60A input and six onboard breakers — a fit for data center and server room racks that need branch-circuit protection segmented across multiple loads rather than a single unprotected feed. This unit ships in red, which on most Server Technology PDU lines signals a specific phase or voltage class at a glance during rack audits.

Overview

This PDU distributes 3-phase, 208V WYE power through six individual breakers, letting you isolate a tripped circuit to a single group of outlets instead of dropping power to the entire rack. The 60A amperage rating sets the ceiling for total connected load across all six branches combined, which matters when you're planning how many servers, switches, or storage shelves this unit can carry before you need a second PDU.

Key Features

• 3-Phase 208V WYE input: WYE configuration delivers both phase-to-phase and phase-to-neutral voltage from the same unit, giving you flexibility to mix single-phase and three-phase loads off one PDU.
• Six onboard breakers: segments the 60A input into six protected branches — a fault on one breaker trips only that branch, not the whole rack.
• 60A amperage rating: sets your total rack load budget; size your server and network gear against this ceiling before populating the cabinet.
• IEC60309 HDOT outlet configuration: HDOT (hexagonal, deep, outlet-type) outlets are a locking connector standard common in data center environments, reducing the risk of accidental cable disconnects in high-traffic racks.
• Red housing: makes phase/voltage identification faster during multi-PDU rack builds where mismatched units are a real risk.

Integration & Compatibility

The C2WG36TE-YQME2966/C (often searched as C2WG36TE YQME2966/C) is built for standard rack PDU mounting and pairs with IEC60309-compatible power cords and equipment already provisioned for HDOT connectors. Confirm your downstream equipment's plug type against the HDOT outlet spec before ordering, since mismatched connector types are the most common return reason on 3-phase PDUs.

Eden Phillips

The C2WG36TE-YQME2966/C is a straightforward 3-phase distribution call: 208V WYE input, 60A rated, six breakers on board. If you're speccing a rack with mixed single- and three-phase loads, WYE is the configuration that gives you that flexibility without a second feed type.

Technical Highlights:

• 60A / 3PH / 208V WYE: defines your maximum connected load and confirms this unit supports both phase-to-phase and phase-to-neutral draws from six branches.
• 6 breakers: isolates faults to individual branches instead of taking the whole rack down on a single overcurrent event.
• IEC60309 HDOT outlets: locking connector standard — check your cord inventory against HDOT before racking this unit.

Deployment Considerations:

• Confirm your upstream panel is actually wired WYE, not delta, before ordering — the two aren't interchangeable on this unit.
• HDOT outlets require matching HDOT-terminated power cords; standard IEC60309 pin-and-sleeve cords without the HDOT lock won't seat correctly.

A fit for a data center rack running mixed 3-phase equipment where you want branch-level breaker isolation across six circuits on a single 60A feed.