Middle Atlantic 1IN TRD SZ Cond FD Assy - 1010CHA

Middle Atlantic 1010CHA 1-Inch Trade Size Conduit Feed Assembly

Overview

The Middle Atlantic 1010CHA is a 1-inch trade size conduit feed assembly designed to provide a clean, managed entry point for conduit runs entering rack enclosures or equipment cabinets. This fitting solves the common installation problem of transitioning conduit infrastructure into structured rack environments without leaving open knockouts or creating cable strain at the entry point — a practical requirement in any deployment where conduit carries low-voltage cabling (power, network, or signal) directly into a rack system. The 1010CHA is the right choice when your AHJ or installation standard requires a proper conduit termination at the enclosure boundary rather than a bare cable pass-through.

Compatibility

The 1010CHA is designed for use with Middle Atlantic rack enclosures and cabinets that accept 1-inch trade size conduit knockouts — the standard knockout size found across Middle Atlantic's rack cabinet lines. Verify your enclosure has a 1-inch (27mm nominal) knockout or pre-punched conduit entry location before ordering. This assembly is not interchangeable with 3/4-inch or 1.25-inch trade size fittings. Compatible with standard EMT, rigid metal conduit (RMC), and intermediate metal conduit (IMC) in 1-inch trade size. For deployments integrating rack enclosure accessories or structured cable management systems, confirm conduit entry placement aligns with your internal cable routing plan before rough-in.