Panduit PWBTB24BL Trapeze Bracket for 24" Wire Basket Tray

The Panduit PWBTB24BL trapeze bracket provides overhead support for 24-inch wire basket cable tray installations in data centers, network closets, and industrial facilities. Designed for ceiling-mount deployment, this bracket suspends wire mesh tray from structural elements—joists, I-beams, or unistrut channels—allowing horizontal cable runs above equipment racks and along overhead pathways. The trapeze geometry distributes load across two mounting points, reducing stress on individual fasteners compared to single-point hangers. Each bracket is fabricated from heavy-gauge steel with a black powder-coat finish for corrosion resistance in climate-controlled environments. Sold in pairs to simplify symmetric installations where trapezes are positioned at regular intervals along tray runs.

Key Features

24-inch (610mm) support width matches Panduit PW-series wire basket widths for direct compatibility

Trapeze profile with dual mounting legs for balanced load distribution across ceiling structure

Heavy-gauge steel construction rated for typical basket tray dynamic loads in commercial installations

Black powder-coat finish resists scratches and environmental exposure in indoor settings

Two-piece package allows symmetric tray suspension at standard 4–6 foot intervals

Pre-drilled mounting holes accept 3/8" or M10 hardware for attachment to threaded rod or unistrut

The trapeze bracket installs between the ceiling structure and the top flange of wire basket tray. The inverted-V geometry provides vertical support while allowing the tray to rest in a horizontal plane. Installers typically suspend these brackets from threaded rod anchored into concrete decks, steel joists, or strut-channel ceiling grids. The bracket's mounting holes are slotted or oversized to accommodate minor alignment adjustments during installation—critical when coordinating tray runs with existing MEP pathways or seismic bracing. The 24-inch span corresponds to Panduit's PW6 and PW12 series basket widths; verify tray profile before ordering to ensure the bracket's cradle geometry matches the tray's top-rail spacing. Mounting hardware (threaded rod, beam clamps, concrete anchors) is sold separately and must be specified based on the ceiling substrate and local seismic/wind load requirements.

Use this bracket in greenfield data center build-outs where cable infrastructure precedes equipment deployment, or in retrofit scenarios where additional tray runs must integrate with legacy overhead pathways. The two-pack configuration supports a single tray span between adjacent trapeze points; for a complete 20-foot tray section at 5-foot spacing, you would order two two-packs (four brackets total). In seismic zones or high-vibration environments, combine trapeze brackets with lateral sway bracing per NFPA 70 Article 392 and local AHJ requirements. The powder-coat finish is rated for standard HVAC environments; for outdoor or corrosive locations (rooftop installations, industrial wash-down areas), specify stainless-steel or hot-dip galvanized alternatives from Panduit's corrosion-resistant product line.

Panduit's wire basket tray system uses trapeze brackets as the primary vertical support element in most installations, paired with splice plates (for tray-to-tray connections) and radius fittings (for direction changes). This bracket is not a hanger rod or a cable support ring—it is specifically engineered for the mechanical and load characteristics of Panduit's basket tray family. Using mismatched or generic brackets can void the tray system's UL listing and compromise load ratings; always specify Panduit-branded supports when building out a PW-series tray run to maintain system certification and warranty coverage.