Vertiv VRA1010 Tool-Less D-Rings Large (Qty. 10)

Overview

The Vertiv VRA1010 delivers a pack of 10 large-format tool-less D-rings for structured cable routing inside open-frame racks and enclosed cabinets. These snap into standard rack rail slots without screws or a screwdriver, which matters during high-density cable dressing passes where stopping to find hardware slows the install. The large ring profile accommodates thicker trunk bundles — think multi-pair fiber runs, grouped Cat6A or trunked power cabling — where the small variant (VRA1008) would pinch or restrict the bend radius.

Compatibility

Designed for Vertiv rack and enclosure systems including the Vertiv VR and VS series open-frame racks and enclosed cabinets. Mount points are standard EIA-310 square-hole and round-hole rack rails at 19-inch spacing, so these also fit compatible third-party rack accessories and enclosures that follow the same rail standard. Use alongside horizontal cable managers in the VRA1000–VRA1003 family, or pair with the VRA1005/VRA1007 Velcro strap line for a complete cable management solution. For smaller cable bundles or patch cord dressing, the VRA1008 (small D-ring, qty 10) is the appropriate step down. For bulk deployments requiring 100 rings per order, the VRA1011 covers the same large-ring spec at higher quantity.

Installation Notes

No tools required — the clip mechanism seats directly into the rack rail punch pattern. Position D-rings before routing cable to avoid having to remove bundles for repositioning. Distribute rings vertically at consistent intervals to maintain even bend-radius support across the full cable run. Combine with ladder rack kits (VRA1025, VRA1026) for overhead-to-rack transitions on structured cabling builds.

What's in the Box

10x Tool-Less D-Rings Large (VRA1010)