Lifesafety Power FPO150-B100C82D8PE4M1/T8-A 150W 8-Output Power Supply
The FPO150-B100C82D8PE4M1/T8-A is a 150W distributed power supply rated 4A at both 12V and 24V outputs—built for access control, surveillance, and door management deployments where you need reliable, independently controlled power rails to multiple locks, readers, and auxiliary devices. This unit ships pre-wired (1502/MR52 tie-wrap configuration) and ready for cabinet or wall mount in your control room or electrical closet.
Overview
Eight isolated distribution rails (8DR E4M configuration) let you assign separate power circuits to different subsystems—a standard requirement in commercial installations where a single fault on one lock or reader shouldn't collapse power to the entire system. The 150W envelope handles mixed 12V and 24V loads across readers, mag locks, exit devices, and auxiliary relays without undersizing or daisy-chaining separate supplies. Pre-wired mercury output connections and included tie-wrap harness reduce bench time and wiring errors on installation.
Compatibility
Works with any access control panel, door controller, or surveillance power distribution scheme that accepts standard 12V and 24V outputs from a distributed power supply. Compatible with Lifesafety Power control ecosystems and third-party systems using conventional relay logic or 24V aux control. Verify your panel's input voltage and current requirements against the 4A per-rail specification before integration.
Installation Notes
Intended for indoor cabinet or closet mounting. Requires standard 120V or 240V AC input (confirm input voltage per your supply datasheet—not specified in available evidence). Tie-wrap harness simplifies routing to multiple lock/reader locations. Isolate output rails by load to prevent single-device faults from affecting other circuits. Test continuity on pre-wired connections before powering on.
What's in the Box
- 1x FPO150-B100C82D8PE4M1/T8-A power supply unit
- Pre-wired mercury connectors (1502/MR52)
- Tie-wrap harness
