Lifesafety Power FPO150/150-C4PD8PE2 Power Supply Enclosure
Overview
The FPO150/150-C4PD8PE2 is a dual-output 150W power supply enclosure designed to distribute power across access control, door locks, and auxiliary systems in small-to-medium security installations. It provides two independent 150W supplies (12A @ 12V or 6A @ 24V per supply) with four dedicated lock outputs and eight class 2 auxiliary outputs limited to 2.5A each — a practical power architecture for integrating multiple door strikes, mag locks, and sensor devices into one enclosure.
Compatibility
Use this enclosure to support access control panels, electric lock hardware, and auxiliary security devices that draw from 12V or 24V DC supplies. The dual-output design lets you run separate circuits — one for high-draw lock hardware, one for control logic or additional auxiliary loads — reducing voltage sag across distributed door strikes and reducing the likelihood of nuisance lock release during simultaneous strikes. Verify that your installed locks and auxiliary devices conform to 2.5A per-channel limits on the eight auxiliary outputs.
Installation Notes
The E2 enclosure rating provides dust protection and corrosion resistance suitable for indoor utility closets and electrical rooms. Ensure incoming AC power matches the supply's input specification and that all DC wiring uses appropriately rated cable for the 12A or 6A maximum per circuit. Lock outputs support direct mag-lock and electric strike connection; auxiliary outputs handle sensor signaling, status indication, and low-current device control. Plan circuit distribution before installation to avoid exceeding the 2.5A auxiliary limit on any single output — overloading a single auxiliary port will not damage adjacent channels but will cause that output to drop.
What's in the Box
- 1x FPO150/150-C4PD8PE2 power supply enclosure with dual 150W supplies
- Installation documentation
