Eaton 010-9341 L6-20P Input Line Cord
Overview
The Eaton 010-9341 is an L6-20P input line cord for hardwired AC connections to Eaton uninterruptible power supplies and industrial power distribution equipment. The L6-20P connector is NEMA 6-20P rated for 20-amp, 250-volt circuits—this rating ensures the cord can safely handle the full inrush and sustained current draw of larger UPS units without voltage drop or thermal stress on the conductor. Deploy this cord in fixed installation pathways where a permanent hardwired connection to your Eaton UPS input is required, not plug-in temporary power.
Compatibility
The 010-9341 integrates with Eaton UPS systems and power distribution equipment that accept L6-20P input connectors via hardwired housings. Confirm your specific Eaton UPS model or power system accepts L6-20P input connectors before ordering—not all Eaton models use this connector type. If your unit expects a different locking connector (e.g., L14-20P, L8-20P, or plug-in IEC receptacles), this cord will not fit.
Installation Notes
The L6-20P connector features a locking pin design: align the pin slots with the receptacle and twist clockwise until fully seated to ensure a secure connection and prevent accidental disconnection during operation. Route the cord in a permanent installation pathway away from foot traffic, sharp edges, and potential pinch points. Installation must follow local electrical code (NEC Article 422, IEC 60364) and building safety standards. Use in indoor, dry environments only unless your specific deployment environment and electrical engineer specify outdoor or wet-rated cord construction. Verify cord gauge and length are appropriate for the distance from your main AC source to the UPS input to minimize voltage drop over the run.
