Geovision 84-VS2820A-001U IP PTZ Camera Cable
Overview
The Geovision 84-VS2820A-001U is a 100-foot dedicated cable assembly engineered for the GV-VS2820 IP PTZ camera system. It combines power delivery and data transmission in a single connector, eliminating the need for separate power and signal runs. This consolidation reduces labor during installation — one cable path through conduit instead of two — and simplifies troubleshooting when PTZ responsiveness issues arise. The integrated design maintains signal integrity during rapid pan, tilt, and zoom operations.
Compatibility
This cable is purpose-built for the Geovision GV-VS2820 IP PTZ camera line and interfaces directly with the controller and camera head. The connector pinout and impedance matching are optimized for PTZ command signals and PoE power delivery. Do not substitute generic Ethernet or power cables — the GV-VS2820 system depends on this specific assembly to maintain signal fidelity during active pan and zoom cycles.
Installation Notes
Route through standard 3/4-inch conduit or cable trays alongside other low-voltage runs. Avoid bundling with 120V or higher AC power lines to prevent noise induction on data lines, which degrades PTZ responsiveness. Secure the connector end at the camera head using the supplied strain relief boot — this prevents connector flex during pan/tilt motion and extends cable life. For runs longer than 100 feet, confirm voltage drop on the power conductors. Long cable runs may require higher-gauge wire or auxiliary power injection depending on the PTZ head's power draw specification.
