Middle Atlantic C3 Credenza Woodkit - 2 BAY 32IN Height IN Kensington Maple - C3K2D1MHE1E1B30000

Middle Atlantic C3K2D1MHE1E1B30000 Credenza Woodkit – 2-Bay, 32in, Kensington Maple HPL

Overview

The C3K2D1MHE1E1B30000 is a woodkit enclosure panel set for Middle Atlantic's C3 Credenza furniture line, configured in a 2-bay layout at 32 inches of total height and finished in Kensington Maple HPL (high-pressure laminate). This kit supplies the exterior wood panels that transform a bare C3 Credenza rack chassis into a finished, client-facing installation — the kind of deployment where the equipment enclosure lives in a conference room, lobby, or executive suite and the finish material has to hold up to daily contact without showing wear. HPL laminate is a practical choice over painted MDF in these environments: it resists scratches and moisture at the surface level, and the Kensington Maple tone blends with commercial wood office furniture without requiring a custom finish order. The 2-bay configuration covers a specific C3 chassis footprint — verify your chassis bay count before ordering, as woodkits are not interchangeable across different bay counts in the Middle Atlantic C3 furniture line.

Compatibility

This woodkit is designed for the Middle Atlantic C3 Credenza chassis series. The 2-bay designation corresponds to the lateral width of the C3 chassis, and the 32-inch height parameter must match your installed chassis height — Middle Atlantic C3 credenzas are available in multiple height configurations, and a mismatched woodkit will not align with the chassis panel attachment points. If you are integrating rack enclosures or AV equipment into a C3 credenza system, confirm the exact chassis part number from your original C3 order before specifying this woodkit. The Kensington Maple HPL finish is one of several laminate options in the C3 line; coordinate with other C3 woodkit panels on the same installation to ensure finish consistency across bays.

Installation Notes

Woodkits for the C3 Credenza attach to the chassis using Middle Atlantic's standard panel-mounting hardware, which is typically included with the chassis or available as a separate fastener kit — verify hardware inclusion against your chassis documentation before installation. HPL panels are factory-cut to chassis tolerances; field trimming is not recommended and will void the fit. For AV furniture installations where cable management routing affects panel placement, plan cable paths before final panel attachment since panel removal after full rack build-out is labor-intensive.