Middle Atlantic AL20GB509TRUSBA 5ft Aluminum Plugmold Dual USB Power Strip
Overview
The Middle Atlantic AL20GB509TRUSBA is a 5-foot aluminum Plugmold multi-outlet strip with alternating AC receptacles and integrated dual USB charging ports. At 6 inches wide (15.2 cm) with an aluminum finish, it is designed for rack enclosures, AV furniture, and security equipment installations where you need both standard AC power and USB device charging consolidated at a single strip — eliminating wall-wart adapters and reducing cable clutter inside the enclosure. The AL20GB509TRUSBA follows the Legrand/Middle Atlantic Plugmold system architecture, which means it pairs with the broader Middle Atlantic product line of rack solutions and enclosure accessories.
Compatibility
The AL20GB509TRUSBA is a Plugmold Multioutlet System component within the power distribution accessory category. It is compatible with Middle Atlantic rack enclosures, credenzas, and AV furniture that accommodate surface-mount or raceway-channel power strips. The aluminum form factor and Plugmold mounting footprint align with Middle Atlantic's enclosure interior dimensions — confirm your specific enclosure model supports the 6-inch strip width and 5-foot run length before ordering. Suitable for deployments powering NVR appliances, PoE switches, access control panels, or AV processing equipment where both AC and USB outputs are required at the same distribution point. For larger power budgets or surge-protected rack distribution, consider pairing with a dedicated rack PDU from the same Middle Atlantic family.
Installation Notes
The aluminum housing is 6 in (15.2 cm) wide — verify this clears any internal rack rails or cable management channels before mounting. The 5-foot strip length determines the outlet spacing across the run; plan your outlet layout relative to equipment positions before committing the strip location. No additional tools or hardware are specified in manufacturer documentation; consult the Middle Atlantic installation guide for surface-mount or channel-mount torque and fastener requirements specific to your enclosure model.
